INPUT CORDS
The "input cord" is the cord between the power supply and the junction/control box. If you have a manufacturer and serial number for your base I can check with my suppliers to determine the correct cord. If you do not know who's base it is, then I need to know what the plug on the power supply and the plug on the control/junction box looks like. I can then match it to one of the cords below.
|
ERGO ESSENTIALS 220 INPUT CORD
Not only is this cord used on most Okin control boxes but also on Keeson control boxes.
$30
220
|
 |
| ERGO ESSENTIALS 220 INPUT CORD |
|
|
OKIN INPUT CORD
This can also be used as an extension cord for the above input cord.
$75
600125
|
 |
| OKIN INPUT/EXTENSION CORD |
|
|
 |
| LINAK INPUT CORD |
|
| LINAK INPUT CORD
$85
8121
|
 |
| ERGO HEAVY DUTY INPUT CORD |
|
| ERGO HEAVY DUTY INPUT CORD
$35
216
|
 |
| HHC/MOTOSLEEP CU20/18/11 INPUT CABLE |
|
| HHC/MOTOSLEEP INPUT CORD
This input cord is used on the CB11, CB18, and CB20 control boxes. One end matches the Motosleep control boxes and the other end matches the generic 24 volt power supplies.
$30
|
 |
| HHC/MOTOSLEEP CU20/18/11 INPUT CABLE PLUGS |
|
|
Copyright 2011-2024 All rights reserved. No parts of this site may be used or copied without prior consent.
|
|